MK Diamond MK-101 Lowes - Manual (Page 34)

34
(J)
Push the motor toward the
front of the Cutting Head to
loosen the Micro-V Belt
(K)
Remove the Micro-V Belt
(L)
Install the new Micro-V Belt
(MK Diamond Part No. 158194)
(M)
Verify the Micro-V Belt is
seated in the grooves of both
pulleys
(N)
Tighten the Motor Adjustment
Strap to remove slack
(O)
Check Micro-V Belt tension (prop-
er tension 1/8-inch) Repeat steps
N and O until proper Micro-V Belt
tension is achieved
(P)
Tighten the four motor
mounting bolts
(Q)
Install the Belt Guard
MK-101 MaiNTeNaNCe