MK Diamond TX-3 - Manual (Page 23)

23
TX-3 OPERATION
4.
5.
6. Shift Plunge Lock Lever (Q) back while Cutting Head Assembly (N) is at uppermost position.
Bring Cutting Head Assembly (N) down to stop on the Plunge Lock Lever (Q).
Tighten Cutting Head Knob (O) for normal operations.
N
O
PLUNGE CUTS
1.
2.
3. Loosen Cutting Head Knob (O) so that the Cutting Head Assembly (N) will swing upward.
Shift Plunge Lock Lever (Q) forward.
Push Cutting Head Handle (P) downward to perform plunge cuts.
P
Q