MK Diamond MK-2000 Pro - Manual (Page 30)

MK-2000 Pro Revision 01/02, Effective Date January 10, 2002 Page 30
MAINTENANCE AND TROUBLESHOOTING
7. Protective Wooden Strip Replacement:
The protective wooden strip is to protect the Movable Cutting Table from damage during operation. Over
time, the wooden strip will become grooved from use. A grooved wooden strip will not support masonry
during cutting causing the blade to "break through" the piece instead of performing a smooth cut (MK
Diamond Part No. – 156427).
8. Changing Voltage Setting:
Perform the following steps to change the voltage setting between 115v and 230v.
The power must be removed from the saw before changing the voltage setting.
(C)
Remove the two Protective
Wooden Strip Retaining Screws
using a Phillips Screwdriver
(B)
Place the Movable Cutting
Table on a Workbench with the
Roller Wheels facing up
(A)
Remove the Movable Cutting
Table
Roller Wheels
Movable
Cutting Table Retaining Screw
Phillips
Screwdriver
Retaining Screw
Phillips
Screwdriver
(F)
Remove the Movable Cutting
Table
Movable
Cutting Table
(D)
Replace the worn Protective
Wooden Strip with the new
Protective Wooden Strip
Worn Wooden
Strip
New Wooden
Strip
(E)
Place the Movable Cutting Table
on a Workbench with the Roller
Wheels facing up and reinstall
the Retaining Screws
(C)
Reinstall the Locking Screw
(B)
Move the Voltage Change
Switch to the desired voltage
setting
(A)
Remove the Voltage Change
Switch Locking Screw using a
Flat Blade Screwdriver
Voltage
Change Switch
Flat Blade
Screwdriver
Locking
Screw
Move Switch
Locking
Screw