MK Diamond MK-6000 Series - Manual (Page 22)

22
3. Pull off vi-lock washers and outer flange.
4. Install new blade.
5. Slide the outer flange in place.
6. Slide on the vi-lock washers. Ensure the stepped
ridges face each other.
7. Tighten the arbor bolt.
8. Install the blade guard in place. Make sure that the
guard locks in place and connect the hose.
MK-6000 SaW oPeration
2. Remove arbor bolt. If blade is mounted on right side saw,
the bolt has left hand threads. To remove turn clockwise.
If the blade is mounted on left side of saw, bolt has right
hand threads. To remove, turn counter-clockwise.
BLaDe MountinG inStruCtionS
1. Remove Blade Guard.
unscrew Hose Fitting
notiCe
Before mounting the blade, machine should be turned “OFF”. Clean the blade collars and stub shaft.
release inner Latch
A. Unscrew the hose fitting to disconnect hose.
B. hold the Blade Guard by the handle. Release the inner latch.
C. Pull the guard up and off the Saw.
install Blade Guard
remove arbor bolt
replace Washers