MK Diamond MK-101 Blade Alignment - Manual

MK-101 Type Blade Alignment Revision 12/00, Effective Date: December 04, 2000 Page-1
MK-101 TYPE BLADE ALIGNMENT PROCEDURE
The Movable Cutting Table of the MK-101 may become misaligned with the Cutting Head of the Tile Saw over
time. Should misalignment occur, perform the following steps to realign the Tile Saw.
NOTE: If alignment problems are the result of a warped blade, a bent frame or bent support arm, or, if alignment
is off by more than 1/8-inch, contact the MK Diamond Service Center – (800) 474-5594
Tools Needed:
Preparation:
1/2-inch Wrench or
MK Triple Hole Box Wrench
and MK Open End Wrench
Combination Square (Square)
12-inch or Greater
(A)
Remove Tile Saw
from Power Source
(C)
Inspect Tile Saw
for damage
(D)
Inspect Diamond Blade
for damage
(B)
Remove Water Pan
(E)
Loosen front and rear
Guide Bar Retaining Bolts
Disconnect Saw
Remove Pan
Inspect
Blade
Inspect Cutting Head Inspect Frame
Turn Counter-
clockwise
to Loosen
Inspect Cutting Table