MK Diamond MK-VTS-50 - Manual (Page 13)

13
(C)
Lay Floor Scraper back on
handles
MK-VTS/50 FLOOR SCRAPER GENERAL OPERATION
Do not operate machine around excessive moisture areas, such as abatement work and flooded pool
areas without GFCI wall plug. Failure to do so could cause damage in machine or injury to operator.
Before using the machine, check for any broken, worn or damage parts and replace them immediately.
WARNING
Adjusting the wheel angle will change the blade angle to the floor. Adjustments may be required for
your particular application. Experiment with the angle to see what works the best.
WHEEL ADJUSTMENT
Adjustment by trial at the beginning of a job will allow optimum performance. See Blade
Usage page 15.
(A)
A steep wheel angle is
recommended on hard
removals such as vinyl, VCT
and carpet over concrete or
wood
(D)
Rotate the angle adjust-
ment wheel to the desired
blade angle
(B)
A low wheel angle is recom-
mended for hardwood
removal over all floors
NOTE: