MK Diamond Sawtec SDG-103 - Manual (Page 15)

15
HANDLEBAR ADJUSTMENT
Adjust the Handlebar, as shown in the figure to the proper height for the operator. Lock handle
into place with locking lever.
Adjust wheel height to ensure grinding plate sits level on the ground. This adjustment makes the
grinding head perpendicular to the ground. In the event of the grinder pulling to one side all the time,
adjust the axle height.
SDG OPERATION
NOTE: Always be sure that the folding handlebar latch
is secure and check during operation that it has
not vibrated loose.
wHEEL HEIGHT ADJUSTMENT
Turn wheel adjustment lock
clockwise.
Rotate wheel adjustment
handle to desired height.
Turn wheel adjustment lock
counter clockwise.
SHROUD
The shroud has two removable sections to enable the operator to grind close to the walls etc.
NOTE: Dust loss is possible when removing any section of the shroud.
DO NOT make any adjustments while the machine is in operation. Any adjustments
must only be performed when machine is stopped and power disconnected.
Insert Allen wrench and
unscrew bolt. Repeat on
other side of shroud.
Remove shroud.