MotorGuide Pinpoint GPS - Manual (Page 17)

PRODUCT INSTALLATION AND OPERATION
eng
11
IMPORTANT: A fixed GPS position is required to complete the compass calibration.
The Xi5 will emit an audible tune once it has acquired a fixed GPS position (in the
default audio mode), and the GPS status indicator light will illuminate.
a - Manual mode
b - #1 button
1. Locate a suitable area clear of obstructions to navigation (both above and below
the waterline) to perform the compass calibration.
2. Deploy the trolling motor. Verify that you are in a location where your trolling
motor and primary propulsion engine will not hit bottom or other obstructions.
3. Press and hold the manual mode button, then press 1, 1, 1. The trolling motor
will emit three ascending‑tone beeps.
4. Use the primary propulsion engine to slowly drive the boat in two complete
circles. The trolling motor will emit a tune when the compass calibration is
complete.
RESET TO FACTORY CALIBRATION
To reset the trolling motor to the factory calibration, press and hold the manual mode
button, then press 1, 1, 4.
Operating the Pinpoint GPS System
PINPOINT GPS STARTUP
The global positioning system (GPS) is a satellite‑based navigation system capable
of providing positional information anywhere on Earth, provided that the GPS receiver
has a clear line of sight to at least four GPS satellites.
53737
b
a