MotorGuide BATTERY CHARGERS - Manual (Page 7)

5
14
13
12
11
14.1V
13.5V
Charging Conditioning Maintenance / Float Mode
Typical Average Voltage
Volts
INSTALLATION
All MotorGuide Battery Chargers are designed to be permanently mounted
on-board, and can be mounted vertically or horizontally.
Always mount your Charger in a compartment area that can be properly ventilated
during use.
Do NOT mount on a carpeted surface or in an area that will block air flow around or behind unit.
Do NOT mix battery types on-board. All batteries should be of the same age
and in good operating condition.
Do NOT make any electrical connections to the battery charger or batteries until the following
steps are completed:
11 Easy to follow installation steps:
1. Select a mounting location that allows for free air ventilation with a minimum of 8 inches of clear
unobstructed space around and in front of the battery charger. Open all battery and engine compartments
and ventilate for at least 15 minutes before starting the installation of the battery charger.
2. Confirm the selected mounting location allows for a minimum of 8 inches of free space
around front and sides of the battery charger. Do not install charger on carpeted, upholstered,
FULLY AUTOMATIC CHARGING OVERVIEW CONTINUED
MotorGuide Float / Maintenance - Blue and Green LED Only On
During this mode the red "Charging" LED will turn off indicating that the charging process
is over and the charger is now maintaining your batteries on-board. Only the blue and green
LED will remain on, indicating Power On / Float-Maintenance mode. A precision 13.5 volts
finishing voltage that maintains each battery (step down voltage regulation mode) which is
perfect for short or long storage periods and will never overcharge your batteries.
O V E R V I E W
14
OWNER'S PERIODIC MAINTENANCE GUIDE
Item:
Process:
When:
Battery Connections
Clean and tighten all battery connections. Follow battery manufacturer's
instructions for cleaning a battery. Clean all battery terminals with a
wire brush where required and tighten all battery connections.
Monthly
Item:
Process:
When:
Battery Electrolyte
In the case of flooded batteries, per battery manufactures instructions,
monitor and maintain proper levels of distilled water in each battery.
Monthly
Item:
Process:
When:
DC Output Wiring
Visually inspect all wiring for cuts and abrasions. Contact MotorGuide
if charger needs to be serviced with new wiring.
Monthly
Item:
Process:
When:
AC Power Cord and Mounting Hardware Inspection
Process: Visually inspect the AC power cord. Confirm ground blade
is present and all plug blades are in good conditions and not bent out
of place.
Check all mounting hardware to ensure there is no loose hardware.
Tighten were required.
Monthly
M A I N T E N A N C E