Mark for canada – MTS Multi-Pump Control Manager User Manual
Page 8
Advertising
Multi-Pump Control Manager
8
Specifications
Introduction
Note
Electrical connections must be made by qualified personnel and conform
to local codes and regulations. Local electrical codes supersede any
information found here.
Mark for Canada
This product has been tested to the requirements of CAN/CSA-C22.2 No. 61010-
1, 2nd Edition, including Amendment 1, or a later version of the same standard
incorporating the same level of testing requirements.
Parameter
Specification
Input Voltage
100–240 V AC (single phase)
power factor corrected universal
input
Input Frequency
50–60 Hz
Input Current
4 A at 100 V AC
2 A at 240 V AC
Facility Power Requirements
Provide a dedicated circuit for the
chassis, computer, and monitor.
Input Surge
<50 A
Over Voltage
Category II
Advertising