MTS Series 793 Controller - Manual (Page 93)

Steps to Run a Test
MTS Series 793 Controller Overview Perform a Practice Test 93
7. Set up the test monitor.
Set up the Meters and Scope as desired to monitor test signals.
8. Set up a test program.
A. From the Application control bar, select Basic TestWare.
B. In the Command tab, set the following:
Note Ensure that the Target Setpoint and Amplitude values are appropriate for
your particular specimen.
C ONTROL S ETTING
Type Cyclic
Channel Channel 1
Control Mode Force
Target Setpoint Guideline: 25% of full scale
Amplitude Guideline: 10% of full scale
Frequency 1 Hz
Wave Shape Sine Tapered
Compensator None
Start Action Disabled
Done Action Disabled