Purenex Multipure Aquaversa - Manual (Page 5)

The Models MP750sC, MPCT, and MP880sC Drinking water systems are
designed for use on the countertop adjacent to your sink. Countertop models
offer outstanding performance and high-quality features. Designed for con-
venience, countertop units are easily attached to most faucets without the use
of special tools. Multipure’s countertop models include easy-to-use diverters
that allow you to switch from filtered to unfiltered water.
Your Countertop unit is shipped with the accessories and fittings required to
complete the installation.
should you require assistance, please contact your Independent Distributor; if
she/he is not able to help you, please feel free to contact Multipure's
Customer service Department.
Please follow the easy procedures outlined in this manual to assure a
smooth installation and system start-up.
1. Inspect your Drinking Water System to confirm that it has been received in good condition and that all parts
are included (see diagrams and parts list on page 4).
2. Determine the type of unit you will be installing and the installation procedures to follow.
3. Review the instructions for your type of unit.
5
II. Countertop Installations - Preparing the Housing
Model MP750SC
1. Installing the Filter
2. Connecting the Hose and Diverter Valve to Your Faucet
3. Connecting the drinking water system
4. Start-up and Use of Your Countertop Drinking Water System
We recommend that you proceed with your installation in the following order:
Filter Cartridge Installation
The filter cartridge is shipped outside of the unit housing (in most cases) to protect your filter
and drinking water system from damage during shipping. Be sure to insert the filter cartridge
into the drinking water system housing before proceeding with the installation.
First, remove the plastic wrapper and instruction wrap from around the filter.
1. with the housing in an upright position, open the unit by unscrewing the black knob on the
locking V-Band. spread it apart and remove the locking V-Band.
2. separate the unit, leaving the black o-ring in place on the housing.
3. screw the new filter (cartridge) in the housing top, turning the cartridge until firm. Be sure
that the filter has been screwed in sTraIGHT. DO nOT OVer TIGHTen.
4. reconnect the housing top with bottom and replace locking V-Band; replace black knob
and turn until tight. Be sure that the locking V-Band is fastened tightly by:
a. Checking the V-Band to confirm that it is secured evenly around the housing top and
bottom.
b. Hand-tightening the black knob on the V-Band until it is as tight as possible.
turn to
connect