Multiquip MVC82VE/VEW - Manual (Page 20)

PAGE 20 — MVC82VE/VEW COMPACTOR • OPERATION AND PARTS MANUAL — REV. #0 (02/05/09)
MAINTENANCE
INSPECTION AND MAINTENANCE TABLES
To make sure your plate compactor is always in good
working condition before using, carry out the maintenance
inspection in accordance with Tables 5 and 6.
CAUTION
Inspection and other services should always be carried
out on hard and level ground with the engine shut
down.
Machine Inspection Table 5.
Item Frequency of Inspection
Loose or Missing Screws Every 8 hours (daily)
Damaged Parts Every 8 hours (daily)
Function of Controlling
System Part
Every 100 hours
Vibrator Oil Check Every 100 hours
Vibrator Oil Replacement Every 300 hours
Hydraulic Oil Check Every 100 hours
Hydraulic Oil
Replacement After fi rst 200 hours, then
every 1,000 hours
V-belt (clutch) Check Every 200 hours
NOTICE
These inspection intervals are for operation under
normal conditions. Adjust your inspection intervals
based on the number of hours the plate compactor
has been in use, and the type of working conditions it
is being used.
NOTICE
Fuel piping and connections should be replaced every
2 years.
DAILY SERVICE
Check for leakage of fuel or oil. 1.
Check for loose screws including tightness. See Table 7 2.
(Tightening Torque) for retightening.
Engine Check Table 6.
Item Frequency of Inspection
Oil or Fuel Leak Every 8 hours (daily)
Tightness of Fastening
Threads
Every 8 hours (daily)
Engine Oil Check and
Replenishment
Every 8 hours (daily)
(Replenish to specifi ed
maximum level)
Engine Oil Replacement
After fi rst 25 hours then
every 50 to 100 hours
Valve Clearance
(Check/Adjust)
After fi rst 25 hours then
every 200 hours or every
year.
Air Filter Cleaning Every 100 hours
See separate engine manual for details on engine check .
Tightening Torque (kg cm) Table 7.
Material
Diameter
6mm 8mm 10mm 12mm 14mm 16mm 18mm 20mm
4T 70 150 300 500 750 1,100 1,400 2,000
6-8T 100 250 500 800 1,300 2,000 2,700 3,800
11T 150 400 800 1,200 2,000 2,900 4,200 5,600
* 100
300-
350
650-
700
* (for aluminum counterpart)
(Threads in use with this machine are all right-handed)
Material and quality of material is marked on each bolt and screw.