Multiquip MVH306GH - Manual (Page 19)

MVH306GH PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #8 (01/31/14) — PAGE 19
TRAVELING
Figure 20. Throttle Lever (Fast)
1. Grasp the compactor's hand grip (Figure 20), and move the
engine throttle lever (Figure 20) quickly to the fast position.
2. With the throttle lever in the fast position, the engine speed
should be around 3,600 RPM, therefore engaging the cen-
trifugal clutch.
3. Place the choke lever (Figure 16) in the " OPEN " position
if starting a cold engine.
4. Place the choke lever (Figure 17) in the " CLOSED " position
if starting a warm engine or the temperature is warm.
Figure 16. Engine Choke Lever (Open)
Figure 17. Engine Choke Lever (Closed)
6. Grasp the starter grip (Figure 19) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.
7. If the engine has started, slowly return the choke lever
(Figure 17) to the CLOSED position. If the engine has not
started repeat steps 1 through 6.
Figure 19. Starter Grip
8. Before the compactor is placed into operation, run the engine
for several minutes. Check for fuel leaks, and noises that
would be associated with a loose component.
5. Place the engine ON/OFF switch (Figure 18) in the " ON "
position.
Figure 18. Engine ON/OFF Switch (ON Position)
OPERATION
ALWAYS move the throttle lever quickly without hesitation,
because increasing the engine speed slowly causes the
clutch to slip.
NOTICE