Multiquip WTE5C Operation Manual - Manual (Page 19)

WT5C/WTe5C WaTer Trailer • operaTion manual — rev. #1 (06/05/13) — page 19
operation
8. If the engine has started, and the choke lever was
moved to the CloSeD position to start the engine,
gradually move the choke lever to the open position
(Figure 9) as the engine warms up. If the engine has
not started repeat steps 1 through 6.
9. Before the water trailer is placed into operation, run
the engine for several minutes.
10. Check for fuel leaks and noises that would be
associated with a loose component. Check for leaks
between pump and engine. If water is leaking between
the pump and engine housing, the seal inside the
pump may be worn or damaged. Continued operation
of the pump is not recommended. Further usage of the
pump under these conditions may cause severe water
damage to engine.
11. To begin pumping, place the throttle lever (Figure 12)
in the run position.
Figure 12. Throttle Lever (Run) .
12. Set manifold and spray bar control handles as
referenced in Table 5 to activate pumping.
Stopping The Engine
Normal Shutdown
1. Move the throttle lever to the IDLE position (Figure
13) and run the engine for three minutes at low speed.
Figure 13. Throttle Lever (Idle)
2. After the engine cools, turn the engine ON/OFF switch
to the oFF position (Figure 14).
Figure 14. Engine ON/OFF Switch (OFF Position)
3. Place the fuel shut-off lever (Figure 15) in the oFF
position.
Figure 15. Fuel Valve Lever (OFF)
Emergency Showdown
1. Move the throttle lever quickly to the IDLE position, and
place the engine ON/OFF switch in the oFF position.