Nameplate and decals, Figure 38 nameplate and decals, Warning – Multiquip MP200SDLSM Operation Manual User Manual

Page 52

Advertising
background image

PAGE 52 —DRY PRIME PUMP — OPERATION MANUAL — REV. #3 (10/06/08)

NAMEPLATE AND DECALS

Figure 38 Nameplate and Decals

Engine

exhaust

and

some

of

its constituents, and some dust created

of California to cause cancer, birth

defects and other reproductive harm.

by power sanding, sawing, grinding,
drilling and other construction activities
contains chemicals known to the State

Some examples of these chemicals are:

Lead from lead-based paints.
Crystalline silica from bricks.
Cement and other masonry products.
Arsenic and chromium from chemically
treated lumber.

Your risk from these exposures varies,

depending on how often you do this type

of work. To reduce your exposure to
these chemicals:

work in a

ALWAYS

well ventilated area, and work with
approved safety equipment, such as
dust masks that are specially designed
to filter out microscopic particles.

WARNING

DIESEL FUEL can cause
fire or explosion.

DCL184

Stop engine before fueling

Keep cigarettes, sparks
and flame away.

BRAKES OFF

TOWABLE

BRAKES ON

DO NOT TOW

WARNING

Tire, wheel or lug nut failure can cause loss of
control. Before towing, you must CHECK:

1. Tire pressure and tread.
2. Tires and wheels for damage.
3. Lug nuts for tightness.

For new and remounted wheels,
re-tighten lug nuts at the first
10, 25 and 50 miles of driving.

Tires and wheels ok?

Lug Nuts
TIGHT?

WARNING

Uncoupling will cause trailer to come
loose from tow vehicle. You must:

1. CHECK that ball LOAD RATING is same

as or greater than coupler LOAD RATING.

2. CHECK that ball SIZE is same as coupler.
3. CLOSE COUPLER CLAMP on ball.
4. LIFT coupler upwards to test that it

will not separate from ball.

5. LOCK coupler clamp with pin or padlock.

Open
Clamp

Pin or padlock

in place

Lift Coupler to check

Closed clamp

WARNING

ALWAYS use safety chains.
Chains hold trailer if connection fails.
You must:

1. CROSS chains underneath coupler.
2. ALLOW slack for trailer to turn.
3. ATTACH chain hooks securely to tow

vehicle frame.

CROSS CHAINS

ENOUGH SLACK
FOR TURNS

ATTACH HOOKS TO TOW VEHICLE FRAME

WARNING

Lights can prevent trailer from being
hit by other vehicles. You must:

1. CONNECT trailer and tow vehicle

electrical connectors.

2. CHECK all lights, taill lights, turn

signal, and brake lights.

3. DO NOT TOW if lights are not

working.

DISCONNECTED CONNECTED

The weight of cargo should never exceed XXX kg. Or XXX lbs

.

TIRE

FRONT

REAR

SPARE

SIZE

COLD TIRE PRESSURE

TIRE AND LOADING INFORMATION

SEE OWNER’S

MANUAL FOR

ADDITIONAL

INFORMATION

Advertising