Troubleshooting (generator) – Multiquip GAC-9.7HZ User Manual

Page 32

Advertising
background image

page 32 — gaC9.7HZ 60 HZ geNeRaTOR• OpeRaTiON aNd paRTs maNual — Rev. #2 (03/31/10)

Table 7. generator Troubleshooting

symptom

possible problem

solution

Low voltage

Engine speed too low?

Raise engine speed to rated RPM.

Low voltage. Engine speed normal

3650 RPM (unloaded), 2500 RPM

(idle)

AC voltmeter not working?

Replace Ac voltmeter.

Control box internal wiring

malfunction?

Check control box wiring.

Defective ignition coil?

Check red and green ignition wires.

Replace ignition wires if necessary.

Rotor winding malfunction?

Check or replace rotor.

Stator winding malfunction?

Check or replace stator.

Leakage breaker malfunction?

Check or replace CB1.

Full power switch malfunction?

Check full power switch and full power

switch circuit.

Voltage output too high.

Engine speed too high?

Lower engine speed to rated RPM.

Voltage output too high. Engine speed

normal 3650 RPM (unloaded), 2500

RPM (idle)

Control box internal wiring

malfunction

Check control box wiring.

Circuit breaker will not turn on "NO

LOAD"

Defective circuit breaker?

Replace circuit breaker.

Circuit breaker will turn on "LOADED"

but trips immediately.

Overload Condition?

Reduce load or replace breaker.

Load circuit is shorted?

Check load circuit for short.

Does not accelerate from low to high

"NO LOAD"

Stuck solenoid?

Check solenoid.

Bad Idle control switch?

Check or replace idle control switch.

Does not accelerate from low to high

"LOAD ACTIVE"

Idle control switch malfunction?

Check or replace idle control switch.

Idle control device malfunction?

Check or replace idle control device.

Control box interal wiring defective?

Check control box wiring.

Does not decelerate no"VOLTAGE

OUTPUT".

Defective rotor windings?

Check or replace rotor.

Defective solenoid?

Check or replace solenoid.

Defective idle control device?

Check or replace idle control device.

Defective solenoid?

Check or replace idle control device.

Does not decelerate but has

"VOLTAGE OUTPUT".

Control box wiring malfunction?

Check control box wiring, replace any

defective components.

Defective solenoid?

Check or replace solenoid.

Idle control device malfunction?

Check or replace idle control device.

trOublesHOOting (generatOr)

Advertising