Multiquip MC94S_P - Manual (Page 28)

PAGE 28 —MC94P/S CONCRETE MIXERS — OPERATION AND PARTS MANUAL — REV. #9 (09/15/11)
Lug Nut Torque Requirements
It is extremely important to apply and maintain proper wheel
mounting torque on the trailer. Be sure to use only the fas-
teners matched to the cone angle of the wheel. Proper pro-
cedure for attachment of the wheels is as follows:
1. Start all wheel lug nuts by hand.
2. Torque all lug nuts in sequence. See Figure 31. DO NOT
torque the wheel lug nuts all the way down. Tighten each lug
nut in 3 separate passes as defined by Table 10.
3. After first road use, retorque all lug nuts in sequence. Check
all wheel lug nuts periodically.
NEVER! use an pneumatic air gun
to tighten wheel lug nuts.
Figure 31. Wheel Lug Nuts Tightening Sequence
NOTE
Mixer Storage
For storage of the mixer for over 30 days, the following is
recommended:
 Drain the fuel tank completely, or add STA-BIL to the
fuel.
 Run the engine until the fuel is completely consumed.
 Completely drain used oil from the engine crankcase
and fill with fresh clean oil, then follow the procedures
described in the engine manual for engine storage.
 Clean the entire mixer and engine compartment.
 Place the mixing drum in the down position (mouth facing
downward).
 Cover the mixer and place it a clean dry area, that is
protected from harsh elements.
MC94P/S CONCRETE MIXER — MAINTENANCE (MIXER)