BenQ SP920 - Manual (Page 30)

30 Operation
Eng
lish Selecting the aspect ratio
The 'aspect ratio' is the ratio of the image width to the image height. Most analog TV and computers are in 4:3
ratio, and digital TV and DVDs are usually in 16:9 ratio.
With the advent of digital signal processing, digital display devices like this projector can dynamically stretch and
scale the image output to a different aspect than that of the image input signal.
To change the projected picture ratio (no matter what aspect the source is):
•
Using the remote control
1. Press ASPECT to show the current setting.
2. Press ASPECT repeatedly to select an aspect ratio to suit the
format of the video signal and your display requirements.
• Using the OSD menu
1. Press MENU/EXIT and then press / until the DISPLAY
menu is highlighted.
2. Press to highlight Aspect Ratio.
3. Press / to select an aspect ratio to suit the format of the
video signal and your display requirements.
About the aspect ratio
In the pictures below, the black portions are inactive areas and the white portions are active areas.
1. 4:3: Scales an image so that it is displayed in the center of the
screen with a 4:3 aspect ratio. This is most suitable for 4:3 images
like computer monitors, standard definition TV and 4:3 aspect
DVD movies, as it displays them without aspect alteration.
2. 16:9: Scales an image so that it is displayed in the center of the
screen with a 16:9 aspect ratio. This is most suitable for images
which are already in a 16:9 aspect, like high definition TV, as it
displays them without aspect alteration.
3. Auto: Scales an image proportionally to fit the projector's native
resolution in its horizontal width. This is suitable for the
incoming image which is neither in 4:3 nor 16:9 and you want to
make most use of the screen without altering the image's aspect
ratio.
4. Real: The image is projected as its original resolution, and with
no pixel conversion. For input signals with lower resolutions, the
projected image will display smaller than if resized to full screen.
You could adjust the zoom setting or move the projector towards
the screen to increase the image size if necessary. You may also
need to refocus the projector after making these adjustments.
4:3 picture
16:9 picture
16:10 picture
15:9 picture
4:3 picture
16:9 picture
OSD menus can be displayed
on those unused black areas.