Multiquip MB25HD - Manual (Page 9)

MB25hd reBar BeNder • operaTioN aNd parTs MaNual — rev. #0 (04/05/10) — page 9
COMpOnents
Figure 1. MB25HD Components
Figure 1 shows the components of the MB25HD Rebar
Bender. These components are described below.
1.
Table — Holds the roller, collar, stopper and the rebar
to be bended.
2. roller — Works in combination with the collar
depending on the diameter of the rebar to bend.
3. Collar — Works in combination with the roller
depending on the diameter of the rebar to bend.
4. stopper — Holds the rebar in place when bending.
5. handle — Used to lift the rebar bender.
6. angle select dial — Sets the angle that the rebar is
going to be bent.
7. emergency stop switch — Stops the rebar bending
and moves the roller back to the starting position.
8. power switch — Turns the power of the rebar bender
on or off.
9. pilot lamp — Indicates rebar unit is on.
10. start switch — Starts the bending process.
11. Connector (for foot switch) — Connects to the foot
switch to start the machine with a push of the pedal.
12. power Cord — Connect to a 120V, 60 Hz receptacle.