Hs62 cut-off saw — saw assembly instructions – Multiquip HS62 User Manual
Page 19
HS62 CUT-OFF SAW — OPERATION & PARTS MANUAL — REV. #5 (09/12/05) — PAGE 19
HS62 CUT-OFF SAW — SAW ASSEMBLY INSTRUCTIONS
Reversing the Cutting Arm Procedure
NOTE
This assembly procedure permits the operator to reorient the
cutting blade
closer to a wall, column
and/or object.
The Multiquip
Side Winder
Cut-Off Saw comes with a Tool Kit
(Figure 16) that assist you with day to day operations. You will
need these tools for the assembly of your saw.
Item
G
is a versatile screwdriver/wrench that accommodates
common bolt/screw and nut head sizes of your saw.
Item
H
is the wrench necessary to accommodate various allen
screws.
Figure 16. Tool Kit
This position displays the
cutting blade on the inside
(center)
cutting position. To reverse the blade position continue with the
following steps:
Remove the following items from the
Cutting Arm Assembly
to expose the V-belt:
■ Guard Adjustment Knob
I
■ Two Cap Screws
J
■ Cover Guard
K
Figure 17. Inside Center Cutting Position
Loosen the
belt tensioning cam
L
and remove the three
nuts and washers
M
. This will take tension off the V-belt, and
permit you to reverse the
cutting arm
.
Figure 18. Belt Tensioning Cam
Figure 22. Water Kit Assembly Points