Multiquip DCA70SSJU2 User Manual

Page 36

Advertising
background image

PAGE 36 — DCA-70SSJU2 (60 HZ) — OPERATION AND PARTS MANUAL — REV. #0 (05/10/06)

Figure 43. Pre-Heat Indicator Lamp

7. If starting the generator in cold weather the preheat lamp

will illuminate (Figure 43), automatically when the Auto-
Off/Reset-Manual switch has been placed in the manual
position. After the glow plugs have been warmed the
pre-heat lamp will go off and the engine start.

Figure 42. Auto-Off/Reset Switch (Manual)

DCA-70SSJU2 (60 Hz) — GENERATOR START-UP PROCEDURE (MANUAL)

The engine's exhaust contains harmful emissions.
ALWAYS have adequate ventilation when operating.
Direct exhaust away from nearby personnel.

Before Starting

Figure 40. Engine Enclosure Doors

1. Place the

main, G.F.C.I., and aux. circuit breakers

(Figure 39) in the OFF position prior to starting the engine.

2. Connect the load to the

receptacles or the Output

Terminal Lugs as shown in Figure 13. These load
connection points can be found on the output terminal
panel and the output terminal panel’s hard wire hookup
panel.

3. The output terminal lugs are protected by a plastic cover.

Remove this cover to gain access to the terminals.
Tighten terminal nuts securely to prevent load wires from
slipping out.

4. Close all engine enclosure doors (Figure 40).

Figure 39. Main, Aux. and GFCI

Circuit Breakers (OFF)

NEVER! manually start the engine with the main, GFCI
or

auxiliary circuit breakers in the ON (closed) position.

5. Place the

voltage selector switch in the desired voltage

position (Figure 41).

Figure 41. Voltage

Selector Switch

CAUTION - LETHAL EXHAUST HAZARD

WARNING - STARTING THE GENERATOR

6. Place the Auto-Off/Reset-Manual switch in the MANUAL

position to start the engine (Figure 42).

8. Once the engine starts, let it run for 1-2 minutes.

Listen for any abnormal noises. If any abnormalities
exists shutdown the engine and correct the problem.

9. Verify that the Engine Running

status LED on the MPEC unit
(Figure 44) is ON (lit) after the
engine has been started

Figure 44. Engine Running LED (ON)

Advertising