Bose AM259777 - Manual (Page 18)

18
System Installation Instructions
Installing the TV on/off detector (optional)
The TV on/off detector senses whether your TV is on or off. This enables the media center to
automatically switch the TV on, as needed, when another video source (DVD, cable/satellite
box, etc.) is selected. If you choose not to use the sensor, you will need to turn the TV on sep-
arately each time it is needed.
Note: This device will not work with LCD and plasma TVs, so if you are using those devises
you may want to skip these steps.
1. Plug the connector on the end of the cord into the TV SENSOR jack on the back of the
media center.
2. Position the TV on/off detector on the back of your TV as shown in Figure 16.
Note: DO NOT use the mounting strip yet to affix the detector. Wait until your system is oper-
ating and you can determine that the sensor is working properly from this location. Refer to
“Testing the TV on/off detector” in your LIFESTYLE
® Operating Guide.
Figure 16
TV on/off detector installed
on your TV
Note: If you have a projection TV, the bottom rear of the enclosure is the best location for
mounting the detector.
Turning off the internal speakers in your TV
When you listen to TV sound through your LIFESTYLE ® system, the speakers in your TV
should not be on. Use the on-screen menus in your TV to select “Internal Speakers: Off” (your
on-screen message may be different). You can also lower the volume of your TV to its lowest
setting. Refer to your TV owner’s guide for detailed instructions.
TV SENSOR
IR EMITTER
SERIAL DATA
SPEAKER ZONES
1
2
1.1A 33V DC POWER
AM FM 75
ANTENNA
OPTICAL OPTICAL
INPUT OUTPUT AUDIO OUTPUTS
DIGITAL DIGITAL
R
L
RECORD
DIGITAL
R
L
DIGITAL
R
L
DIGITAL
R
L
DIGITAL
R
L
TAPE
AUDIO INPUTS
AUX VCR TV
VIDEO INPUTS COMPOSITE S-VIDEO
COMPOSITE S-VIDEO VIDEO OUTPUTS
Back of TV
TV SENSOR
jack
TV on/off detector
Media center rear panel
Mounting the detector
using the mounting strip
AM259777_02_V.pdf • April 23, 2002