Omnitron Systems Technology iConverter 1 Module Redundant Power Chassis - Manual (Page 9)

Figure 4: 48 VDC and AC/DC Redundant Power Configuration
WARNING: Note the wire colors used in making the positive, negative
and ground connections. Use the same color assignment for the
connection at the circuit breaker.
Connect the power wires to the circuit breaker and switch the circuit breaker
ON. Confirm that the unit has powered up properly by checking the power
status LED located on the front of the installed chassis. See Section 3.2 for the
details concerning the operation and definition of the front panel LEDs.
Page 9