One for All SV 2010 Internet to TV Link 200Mbps - Manual (Page 4)

1. Connect the first adapter to your router/modem;
2. Connect the second adapter to your Internet-enabled TV / Set-Top-Box / Game Console /
Media Player / Blu-ray Player etc.
Your ONE FOR ALL Internet to TV adapters are now READY to use.
Installation
6
English
OFF :
SLOW blinking :
FAST blinking :
OFF :
ON :
BLINKING :
ON :
FAST BLINKING (0.06 s ON/ 0.06 s OFF) :
NORMAL BLINKING (0.2 s ON/ 0.2 s OFF) :
SLOW BLINKING (1 s ON/ 1 s OFF) :
OFF :
SV-2010 = Press and hold for
12 seconds :
SV-2020 = auto-standby :
Reset to factory default :
-> POWER OFF
-> Adapter is in standby.
-> Adapter is doing security key exchange.
This could take up to 2 minutes.
-> No network connection detected.
-> Network connection detected, but no
network traffic.
-> Network traffic detected.
-> Powerline Link detected but no Powerline
traffic.
-> Powerline data rate higher than 60Mbps.
-> Powerline data rate between10Mbps to
60Mbps.
-> Powerline data rate slower than 10Mbps.
-> No Powerline Link detected.
-> Enter standby mode. Press and hold for 1
second to exit standby mode.
-> Will enter standby mode automatically if
ethernet is disconnected for 2 minutes.
Awakes automatically if there are network
activities.
-> Press and hold for 1 second.
Usage
ENHANCED SECURITY
Following these steps below will create enhanced security for your ONE FOR ALL Internet
to TV adapters;
1. Press and hold the Security button on the first adapter for 5-8 seconds and then release.
All LEDs will simultaneously turn off and on once;
2. Press and hold the Security button on the second adapter for 5-8 seconds and then release.
All LEDs will simultaneously turn off and in once;
3. Press Security button on first adapter for 1-3 seconds. The power LED will start blinking;
4. Within 2 minutes press Security button on second adapter for 1-3 seconds. The power LED
will start blinking;
708774_SV-2010-2020_RDN-1100512_INT.PAG:SV-2010_SV-2020 10-05-12 11:45 Pagina 6