Opticon PHL 5200 addendum - Manual (Page 4)

4
ƒ Options: set bar code scanner properties
ƒ Barcodes: set bar code label types
ƒ Menu codes: set customized configuration
ƒ About: read scanner software version and Opticon contact information
Tab Options
Default
The default settings are as displayed in
the Tab Options Image .
For other settings notify the following
descriptions.
Barcode reader
Tick on the box to set the scanner to
enabled or not enabled.
Read mode
The following read modes are
available:
ƒ Single read When a bar code has been decoded, the reader will be turned
OFF. The reader must be triggered again to read another label.
ƒ Multiple read: When a bar code has been decoded, the reader will stay ON
for 2 seconds after the last action. In this reading time different labels can
be scanned. The same label can only be decoded again after the label has
not been detected for a number of scans.
Buzzer
Tick on the box to set the “Goodread” sound ON or OFF.
Default two sounds are available. If other sounds are loaded on the pocket
PC, they will be recognised in the scanner settings menu and can be selected.