Orbit Baby Infant Car Seat G2 and Base G2 - Manual (Page 37)

72
72
Securing Y
our Child
Securing Y
our Child
73
73
To re-install the infant head support:
1. Thread each shoulder strap through the
corresponding slot on the infant head
support.
2. Secure the infant head support around
the shoulder straps by fastening the
hook and loop fasteners. (Photo C).
3. CHECK that the infant head support
does not interfere with the movement
of the shoulder straps.
4. CHECK that the infant head support
does not interfere with a snug fit of the
restraint harness against your child’s
shoulders once secured and snugly
adjusted.
Some smaller infants may need the extra
stability from the infant head support to
keep their head and body in a comfortable
position (Photo A). Remove the infant
head support from your car seat once your
child’s head no longer fits comfortably in
the rolled padding.
To remove the infant head support:
1. Pull apart the hook and loop fasteners
at the outer ends of the two slots of the
infant head support (Photo B).
Using the Infant Head Support
To prevent ejection, shoulder
straps must be routed through
the shoulder strap slots in
both the upholstery and infant
head support.
⚠WARNING⚠
Death or Serious Injury Can Occur
A
B
C