BT CONVERSE 2100 - Manual (Page 14)

If you experience any problems, please visit www.bt.com/producthelp
14 14
1. Unclip the stand from the base of the
phone and remove it. Re-route the
telephone line cord towards the
bottom of the phone.
2. Drill two holes in the wall 70mm
vertically apart using an 8mm drill bit.
3. Insert the wall plugs if necessary, then
insert the screws leaving about 5mm
protruding from the wall on which to
hang the phone.
4. Slot the holes on the back of the base over the screw heads and gently pull the
phone down to fix it securely in place.
Using the handset park when the phone is wall-mounted
If you need to leave the phone whilst on a call, hang the handset on the handset
park at the top of the base.
WARNING
Before you wall-mount your BT Converse 2100,
check that you are not drilling into any hidden
wiring or pipes.
Make sure the telephone line cord will reach the
wall socket.
Wall mounting your phone
WALL
WALL PLUG SCREW
70 mm