Oxford Garden Chadwick 5 Bench - Manual (Page 2)

Step 1
On a clean flat surface, lay right leg assembly 1 on its side
mortise holes facing up. Place the back 3 into the mortise
of the right leg assembly.
Step 3
Line up and place left leg assembly 2 onto those parts
already assembled.
Step 2
Locate the small label on the bottom of the seat that reads “front”.
With the front of the seat toward the front of the bench, line up
and insert the front rail 5 and seat 4 into the right leg assembly.
Insert the large rounded pegs at the front and rear of the seat into
the back and front rail.
Step 4 detail
NOTE: The dowels should be easily driven in flush. If there is
strong resistance, do not force the dowel. Sand to smooth off
areas around the dowel pins.
Step 5
Using a phillips head screwdriver, screw the 8 total wood
screws
B into the predrilled holes on the underside of
the seat to attach the seat to the seat back, front rail and
arm assemblies as shown. Turn bench upright and enjoy!
A
2
Assembly Instructions
page 2
Chadwick Bench - 5'
B
B
B
A
A
A
A
A
3
A
2
Step 4
With a hammer, drive 4 dowels A into the predrilled holes found
on the front of the leg assemblies to hold the front rail 5 into place.
Drive the remaining 8 dowels into the predrilled holes located on
the back of the leg assemblies to hold the back 3 in place. Insert
the tapered end of the dowels first.
4
5