Oyen Digital MINIPRO 2.5" ENCLOSURE SERIES - Manual

/8
/8
/8
/8
(up to 15mm height)
4.9 x 3.2 x 1.0 inches
a) Remove the screw located at the bottom of the case
and slide out the circuit board from the enclosure.
b) Install the hard drive and mount it with the included 4 silver
mounting screws. Do not over-tighten.
If you have installed the drive yourself and this is a brand
new drive, you will have to format the drive before it is accessible.
a) Turn on your computer
b) Connect the MiniPro and turn on the power..
c) Use Disk Management on the PC or Disk Utility on the Mac
to format the drive.
Windows: http://oyendigital.com/FAQs.html#10
Mac: http://oyendigital.com/FAQs.html#8
d) For the safe removal of your drive and to assure that no
data is lost, always eject the external drive from your
system first, before you turn it off or disconnect it.
Location and placing precautions
Do not cover the MiniPro and do not place the unit on other
heat-sensitive equipment. Avoid positioning it in the
following places:
•
Locations with direct sunlight or other sources of heat with
high temperatures (over 120° F) or high humidity (over 90%).
•
Locations subject to vibration or shock.
•
Do not expose the product to water or humid conditions.
Electricity and power adapter
When removing the power cable from the socket, always
pull on the plug fixture and never on the cord.
a) Slide the assembled drive back into the enclosure.
b) Fasten the 4 screws at the bottom of the casing to finish
the assembly. Next, peel off the paper from the back of
the self-adhesive rubber feet. Now, place the rubber feet
over the screws and stick them on the casing to cover the
screws.
(7) Warranty Information
This product includes a one (1) year repair/replacement
warranty provided by Oyen Digital. This warranty is non-
transferable and is limited to the original purchaser. Warranty
service may be requested by completing the form at the
following link: www.oyendigital.com/rma-request-form.html
For our complete warranty policy, visit:
www.oyendigital.com/warranty.html
Q: What file system should I use to format the drive?
A: This will depend on how you want to use the drive but in
general, we recommend:
•
Windows 2000/XP/Vista/7/8 --> NTFS
•
Mac OS X --> HFS+ (Mac OS Extended)
•
For use with both PC and Mac --> FAT32
Q: Can I use my device with bus power only?
A: This will depend on the model, the hard drive, the interface,
and the host computer. Bus power is supported with Firewire
and USB in most situations.
Q: Can I use more than one interface at the same time?
A: No, only one interface can be used at any given time.
Disconnect the previous cable before connecting the new one.
(8) FAQ
MiniPro 2.5” Hard Drive Enclosure
Installation Manual
LED indicator:
OFF = Power OFF
Solid = Power ON
Flashing = Read/Write Access