Pavement Ends 44527 Flip Top - Manual (Page 4)

44527 pg 4 Rev. H 1210
Caution When drilling in the top edge of the vehicle body, check underneath for
wiring for the rear lights. Pull the wiring out of the way before drilling.
Step Three
I NSTALL THE T AILGATE R ETAINER M OUNTS
Locate the left and right Tailgate Retainer Mounts. Place the mounts fl ush with the edge of the tailgate opening.
Install the Tailgate Retainer Mounts with two #8 x 1/2" Pan Head Washer Screws for each mount.
If your vehicle does not have holes at this location, align the Tailgate Retainer Mounts fl ush with the edge of the
tailgate opening. Then mark the locations of the holes in the mounts, center punch and drill a 1/8" hole at the
marked locations. Install the mounts with two #8 x 1/2" Pan Head Washer Screws for each mount.
Tailgate Retainer
Mount (Left)
Tailgate Opening
#8 x 1/2" Pan Head
Washer Screws
Place Tailgate
Mount fl ush with
edge of opening