Pavement Ends 51148 Replay - Manual (Page 3)

51148 pg 3 0710 Rev. C
Step Five
U
NFASTEN
C
ENTER
B
OW
Unfasten the fl ap around the Center Bow.
View from inside vehicle
Sport Bar
Unfasten hook and
loop to unwrap fl ap
Center Bow
Step Six
R
EMOVE
C
ORNER
S
CREWS
Collapse the bow assembly down onto the tailgate.
With the bow assembly laying on the tailgate, remove
the screws that fasten the fabric to the corners of the
header. Set the screws aside for use in installing the
new top fabric.
Detail of Header
Collapse bows and
fabric onto tailgate
Header
Remove Screw
Flip the fabric into the
rear of the vehicle
Step Seven
R
EMOVE
S
CREWS
H
OLDING
F
ABRIC TO
H
EADER
Flip the top fabric back over into the rear of the
vehicle (so that the fabric lays backing side up) to
expose the plastic strip along the edge of the fabric.
Remove the eight or fourteen screws that secure the
fabric to the header. Set the screws aside for use in
installing the new top. Then remove the old top fabric
from the vehicle.
NOTE: Due to a recent header assembly modifi ca-
tion by Daimler Chrysler, the plastic strip on the wind-
shield header may have 8 screw locations instead of
14. Both attachment numbers of screws will securely
fasten the header and perform as the original design
was intende d.
Remove the 8 or 14 screws that
secure the fabric to the header