Paxton OEM marine reader - Manual

Ins-30136 OEM marine reader
09/11/2009
Suitability
Security-sensitive doors Wet environments
Readers mounted together Mounted on metal surface
between readers
300mm
Fitting
Removing the reader
Fix the backplate to the wall with the stainless steel screws provided in the fitting kit. The small slot in the plate
edge should be positioned at the bottom.
Where the unit is to be fitted to a smooth surface, bulkhead, etc. a gasket is supplied to provide a weatherproof
seal between the backplate and the mounting surface. (The unit has its own integral seal)
Locate the unit in the keyhole slots provided in the backplate. Make sure that the locking pin is close to the slot in
the edge of the backplate. Rotate the unit clockwise until the locking pin engages in the slot.
To remove the unit, insert a small screwdriver into the cut out provided and use it to lift the locking pin.
The unit can then be rotated anticlockwise to release it from the backplate.
Output format
This unit will read the data from an EM4100 token or the serial number of a Hitag2 token.
It will output a 26 bit Wiegand number.