Paxton OEM PROXIMITY marine reader EM4100 Wiegand output - Manual

Ins-30083 OEM PROXIMITY marine reader EM4100 Wiegand output
28/10/2009
Suitability
Security-sensitive doors Wet environments
Readers mounted together Mounted on metal surface
between readers
300mm
Fitting
Removing the reader
Fix the backplate to the wall with the stainless steel screws provided in the fitting kit. The small slot in the
plate edge should be positioned at the bottom.
Where the unit is to be fitted to a smooth surface, bulkhead, etc. a gasket is supplied to provide a
weatherproof seal between the backplate and the mounting surface. (The unit has its own integral seal)
Locate the unit in the keyhole slots provided in the backplate. Make sure that the locking pin is close to the
slot in the edge of the backplate. Rotate the unit clockwise until the locking pin engages in the slot.
To remove the unit, insert a small screwdriver into the cut out provided and use it to lift the locking pin.
The unit can then be rotated anticlockwise to release it from the backplate.
Cable extensions
Readers can be extended using Belden CR9540 10-core overall screened cable to a maximum of 100 metres.