Braun 370cc - Manual (Page 8)

8
Description
1 Foil & Cutter cassette
2 Long hair trimmer
3 Precision setting switch («lock»)
4 On/off switch
5 Charging lights (green)
6 Low-charge light (red)
7 Cleaning light (yellow)
8 Replacement light for shaving parts
9 Shaver power socket
10 Special cord set
11 Case
Charging
The best environmental temperature for
charging is between 60 °F to 95 °F / 15 °C to
35 °C. Do not expose the shaver to
temperatures higher than 122 °F / 50 °C for
extended periods of time.
Using the special cord set (10), connect the
shaver to an electrical outlet with the motor
switched off.
When charging for the first time, leave the
shaver to charge continuously for 4 hours.
Subsequent charges will take about 1 hour.
A full charge provides up to 45 minutes of
cordless shaving time depending on your
beard growth.
Shave without the cord. With normal use
the shaver will be charged automatically
after every cleaning in the Clean&Renew™
(see separate use instructions).
Maximum battery capacity will only be
reached after several charging/discharging
cycles.
5-minute quick charge (with the special
cord set (10)) is sufficient for a shave.
If the rechargeable batteries are discharged,
you may also shave by connecting the
shaver to an electrical outlet via the special
cord set.
Charging lights
The green charging lights (5) show the charge
status of the batteries. The green charging
light blinks when the shaver is being charged
•
•
•
•
•
•
•
or switched on. When the battery is fully
charged, all green charging lights shine
permanently, provided the shaver is switched
on or connected to an electrical outlet.
Low-charge light
The red low-charge light (6) flashes when the
battery capacity has dropped below 20%,
provided the shaver is switched on. The
remaining capacity will then be sufficient for
2 to 3 shaves.
A Shaving
Press the on/off switch (4) to operate the
shaver (picture).
The flexible shaving foils automatically adjust
to every contour of your face (picture).
Long hair trimmer
To trim sideburns, moustache or beard, slide
the long hair trimmer (2) upwards.
Precision setting switch («lock»)
For precise handling in hard to shave areas
(e.g. under the nose) slide the switch (3) to
the right to position «lock». The centre trim-
mer and one foil will be lowered.
Tips for the perfect shave
For best results, Braun recommends you
follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right
angles (90°) to your skin.
3. Stretch your skin and shave against the
direction of your beard growth.
B Keeping your shaver in top
shape
Cleaning indicator
Your shaver should be cleaned daily in the
Clean&Renew™, and certainly when the
yellow cleaning light (7) shines constantly
after shaving. If this is not done, the yellow
light will go out after some time. The shaver’s
98715711_Floater390cc_NA_S6-28.i8 8 98715711_Floater390cc_NA_S6-28.i8 8 30.05.2008 12:51:05 Uhr 30.05.2008 12:51:05 Uhr