PIAA 530 Series L.E.D. - Manual (Page 6)

-6-
PKI-0007-3
1
【3】Lamp Installation Procedures
Bracket
Lamp harness
2
3
Remove the lamp harness bullet connectors and take out the lamp.
Install the lamp according to the marking made prior to installation.
◆ If using only the double-side tape.
Peel the protective sheet from the double-sided tape (Item 3) and apply.
● When using the double-side adhesive tape, clean the surface where tape will be applied. Use a clean cloth or
sponge and make sure dirt, grease, wax etc., are completely removed. If substances cannot be removed, it
may not adhere properly. In particular, avoid using leather wax, tire wax and also any type of organic solvent.
● When used in low temperatures, the adhesive substance tends to lose its strength. Use a drier or simply
warm up the adhesive surface before applying. When using a drier, avoid moving it too close to the bumper
as it may cause it to deform.
● After installation, avoid excess speeds and do not wash for 1 to 2 days.
● If applied incorrectly, a special double-sided adhesive tape is available at your local PIAA dealer.
(1) Loosen (+) bolt with Philip s head driver and remove the bracket from the lamp.
(2) Peel off the protective sheet from the double-sided tape and apply it to the bracket.
(3) Fix the bracket in place with the screws.
(4) Install the lamp onto the bracket.
Bracket
Lamp body
Phillips head driver
Double-stick tape
(Item 3)
Temporarily set the bracket with tape and then mark the correct possition.
Temporarily set with tape
Bullet connectors
◆ If using screws(M4 bolt or screw) to fix lamp stably.
Protective sheet
○ ＋ bolt
Screw
(M4 bolt or Screw)