PIAA Deno 6 Daytime Running Lamp - Manual (Page 4)

-4-
PLI-1165
● Before installing to the vehicle, make sure to determine if the lamp will be a hanging type or upright type.
● In this IM, 2 types of wiring methods are explained: wiring allowing the LED to shut off when the headlights are turned on
and wiring allowing the LED to dim when the headlights are turned on.
When preparations and temporary setup of the lamp is complete, determine which wiring system you will use. Then go to
the proper page for instructions.
Wiring allowing the LED to shut off when the headlights are turned on
………… P5 Wire (LED Off)【2】 according to instruction indicated.
Wiring allowing the LED to dim when the headlights are turned on
………… P6 Wire (LED Dim)【3】 according to instruction indicated.
Tools Required
● Philip ' s head driver ● Tape ● Pliers
◆ When you have decided the installation method……
(1) Rearrange the bracket according to your needs,
and apply double-side tape (Item 3) and one-side
tape as shown in the diagram below.
(2) Hold the lamp up to where it will be installed on
the vehicle. Verify the gap between the lamp and
surrounding obstacles.
Double-side tape
(Item 3)
Bracket
Lamp body
Hexagon wrench
(Item 7)
Make sure the installation position is
correct and the logo will not be upside
down.
● The vicinity of the lamp emits considerable heat.
Therafore, a minimum of 5mm of clearance is
required.
● There must be 20mm more side of the lamp to allow
for proper adjustment.
● If using a screw, make sure there is adequate space
between the bracket and the lamp
(where screw will be inserted).
【1】Lamp installation preparations and temporary setup