Practical Instrument Electronics 510B - Manual (Page 3)

Practical Instrument Electronics
82 East main Street Suite 3.14 • Webster, NY 14580 Tel: 585.872.9350 • Fax: 585.872.2638 • [email protected] • www.piecal.com
Page 3
Configuration
Configure the Calibrator
Move w POWER SWITCH to “SOURCE”.
Setup
Double click the
e DIAL KNOB at any time the
unit is on and the following displays will appear
for 15 seconds:
Turn the e DIAL KNOB to move through the
menu. Press the e DIAL KNOB to toggle
between OFF and ON or to scroll through the
settings.
MODEL 51# V#.##
DOUBLE CLICK
EZ-DIAL KNOB
FOR CONFIGURATION
> EXIT 15
TEMP UNITS °C
RTD Pt 100 a=3850
AUTO OFF ON
EXIT MENU - exits this menu immediately and
saves any changes. Menu will automatically exit
after 15 seconds of inactivity (countdown timer is
displayed).
TEMP UNITS - pressing the knob will toggle
between °C and °F.
RTD -
510: pressing the knob will toggle between the
factory configured RTD (Pt, Cu & Ni) and Ohms.
511: pressing the knob will cycle through the ten
different RTD types (Pt, Cu & Ni) at different
base resistances and alpha values and Ohms.
AUTO OFF - If AUTO OFF is ON, the unit will
turn off after 30 minutes of inactivity to save
battery life. If AUTO OFF is OFF the unit will stay
on until the POWER SWITCH is moved to the off
position.
Note: All settings are remembered even with the
power off. Removing the batteries resets the
values to factory defaults.