Self-propelled windrower pre-delivery checklist – MacDon 9352c SP User Manual
Page 149
Form # 147459
Issue 11/06
Self-Propelled Windrower
Pre-Delivery
Checklist
Perform these checks and make adjustments as required prior to delivery to your customer. See the
Operator's Manual for adjustment details.
CAUTION: Carefully follow the instructions given. Be alert for safety related messages which
bring your attention to hazards and unsafe practices.
Serial Numbers:
WINDROWER: ENGINE: ____________________
Check for damage or missing parts. Remove plastic or tape from air cleaner intake and muffler exhaust.
Turn SMV sign reflective side out.
Remove shipping skid shoes from front legs and shipping support from walking beam (yellow parts).
Install tires and torque to specifications (P. 133).
Check tire air pressures and adjust as required (P 133).
Check power hub lubricant level (P. 104).
Check engine coolant level and strength at reserve tank (P. 76).
Check air cleaner and connections (P. 68).
Check hydraulic oil level and check for leaks along lines (P. 88).
Check engine oil level (P. 64).
Check fuel sediment bowl for water & foreign material (P.71). Drain and clean as necessary. Add fuel.
Check bevel gear box lubricant level (P. 92).
Check linkage operation at injector pump (P.67).
Check tension of A/C compressor belt (P. 66).
Install a properly sized and fully charged battery and connect cables (P. 134).
Lubricate the machine completely (P. 61).
Check neutral start system properly adjusted (P. 97).
START ENGINE AND RUN TO OPERATING TEMPERATURE.
Program Mac-Monitor and check for operation (P. 17).
Check instrument console gauges (P. 19) and interior lights (P. 20) for operation
Check engine oil pressure indicator light at Mac-Monitor (P. 18).
Check alternator charge rate at instrument console (P. 19).
Check fuel gauge for operation (P. 19).
Check maximum (no load) engine speed at Mac-Monitor (P. 18):
2530 rpm – Header Not Engaged
Check air conditioning functioning properly (P. 21).
Check exterior lights for operation (P. 20).
Open heater valve at engine compartment if cab heat required (P. 21).
Attach header (P. 40) and complete the Header Pre-Delivery Checklist.
Check that all header controls operate correctly and freely (P. 23).
Remove plastic from seat after pre-delivery is complete.
Date Checked:
Checked by: __________________