MacDon R80 Rotary Disc - Manual (Page 61)

MAINTENANCE/SERVICE
Form # 169089
59
Model Year - 2009
e. Remove four bolts (F).
f. Lift driveline (G) off deflector (A) base and slide
lower end of deflector off disc (H).
Installation
CAUTION
Cutter blades have two cutting edges.
Exercise caution when working around the
blades. Blades are sharp and can cause
serious injury. Wear gloves when handling
blades.
a. Slide driveline (G) upward onto shaft, locate
deflector (A) over driveline, and position
deflector on disc (H).
b. Align cut-outs in base of deflector with cutter
blades.
c. Install four bolts (F), and torque to 92 ft·lbf (125
N·m).
d. Position guard (E) and tighten bolts (D).
e. Position guard (C) and attach with two bolts (B).
f. Remove block of wood if used.
g. Close
doors.
7.8.6.2 Driven Deflector – 13 FT
Removal
a. Place a block of wood between two discs to
prevent deflector from turning.
b. Remove four bolts (J) and remove deflector (K).
Installation
a. Position deflector (K) on disc with cut-outs in
base of deflector lined up with cutter blades.
b. Install bolts (J) and torque to 92 ft·lbf (125 N·m).
c. Remove block of wood if used.
d. Close
doors.
F
G
H
A
F
G
H
A
K
J
B C
D
E
A