MacDon CA25 OM - Manual (Page 35)

SECTION 7. OPERATION - CASE IH
169593
33
Revision B
7.3.2.2 Detachment
a. Choose a level area. Position header slightly
above ground. Stop engine, and remove key.
DANGER
To avoid bodily injury or death from fall of
raised machine, always engage lift
cylinder stops before going under header
for any reason. See your Combine
Operator’s Manual for instructions for use
and storage of header lift cylinder stops.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
b. Engage both adapter float locks by lifting lever
(A) at each lock until it latches into lock position.
IMPORTANT
If slow speed transport wheels are
installed, header may be detached
in either Transport or Field mode.
If detaching with wheel in Field
mode, set wheels to storage or
uppermost working position. Refer
to Section 7.9.1 Cutting Height.
IMPORTANT
If stabilizer wheels are installed, set
wheels to storage or uppermost
working position. Otherwise header
may tilt forward so that
re-attachment will be difficult. Refer
to Section 7.9.1 Cutting Height.
c. Disconnect driveshaft (B) from combine, and
slide driveshaft in hook (C) so that disc (D)
drops to secure driveshaft.
d. Remove electrical connector (E), and replace
cover.
(continued next page)
H
E
J
LOCK
UNLOCK A
B
D
C