MacDon 873 Combine Adapter User Manual
Page 63
Form # 147069
Issue 09/06
61
ATTACH L/H SHIELD: PRIOR TO 50 SERIES
LEVEL LAND
E
D
OFFSET SUPPORT WITH CARRIER ANGLE
B
A
Adapter Mounting Instructions
for John Deere Combines
PREPARING THE ADAPTER – JOHN DEERE PRE 50 SERIES LEVEL LAND COMBINES:
1. 9600, 9610 & Straw Walker Combines:
Install support carrier angle (B) to R/H frame member of
adapter with two 1/2 x 1-1/4 inch carriage bolts and nuts.
Attach offset pump torque arm link (A) to support angle (B)
with 5/8 x 1-3/4 inch hex head bolt and flange nut.
2. Level Land Prior to 50 series Feeder House:
Attach shield (D) to left side of adapter frame.
NOTE: For 9600, 9610 and 8820 combines, shield (E) is
not required. Remove prior to installation of shield (D).
Swing shield (D) forward for end transport situations.
3. All combines except Contour Master with dust shields
removed:
Move bolt (F) and nut (G) to hole (H) for proper float.
4. All combines
Mount pump to gearbox using four Allan head
screws (P) supplied. Secure pump in storage
position on R/H side of adapter frame using lynch
pin.
NOTE: Place washer (M) (supplied) between pump
and gearbox.
NOTE: Allen screws (P) are taped to hydraulic lines of
pump. Torque Allen screws (P) to 14 ft.lbs (20 N.m).
NOTE: Fittings and hoses may need to be re-orientated
to secure for proper storage.
OFFSET SUPPORT
A
G
FLOAT LOCKOUT REPOSITION HARDWARE
H
G
F
M
P