MacDon Transport 25 ft 972 - Manual (Page 4)

SET-UP INSTRUCTIONS
Form # 131126 Issue 11/07 2
LEFT END (FORWARD) WHEEL
1. On bottom flange of left endsheet, drill
two 0.656” holes* (B) as shown.
NOTE: Holes in bottom flange may be
round or square.
* These holes will be present on headers
built in Model Year 2001 and later.
2. Attach left wheel assembly at the two
holes drilled in step 1, using 5/8 x 1-1/4
carriage bolts at (H) (heads down) and
5/8 flange nuts.
3. Mark the position for hole (A) on the
endsheet, using the wheel assembly as
a guide. Drill a 0.656” diameter hole*.
* This hole will be present on headers
built in Model Year 2001 and later.
4. Position brace tube so that hole (C) is
484 mm (19.05”) from left endsheet as
shown. Mark this position and tack weld
a 5/8 x 1 inch black bolt from kit to main
tube. Position brace onto bolt and
confirm proper bolt position, then
remove brace from bolt and place a 5
mm (3/16”) weld completely around bolt
head.
NOTE: Ends of brace will bend slightly when initially tightened.
26 mm = 1.02”
170 mm = 6.69”
193 mm = 7.60”
LEFT ENDSHEET HOLES
LEFT ENDSHEET HOLE & WELDED BOLT