MacDon 802 Bi-Directional Adapter - Manual (Page 10)

9
INITIAL SET-UP
PREPARING THE ADAPTER
1. Check that pin (A) is in working position and
pin (B) in float lockout position as shown.
Repeat at other side.
NOTE: At L/H side, pin (B) goes through
round hole instead of slot. Loosen float
springs to line up slot/hole for pin installation.
IMPORTANT: Damage to float may occur if
pin (B) is not under frame on both sides.
2. Move crop deflector (C) to correct position for
the application as shown below. For headers
with hay conditioners, remove crop deflector
(C). See following page for instructions.
NOTE: Adapters can be ordered in two
configurations:
A. For 9030 Tractor or TV140 Tractor without
Auxiliary Pump. This configuration includes a
MacDon supplied header drive pump that runs
off the tractor PTO.
B. For TV140 Tractor with Auxiliary Pump (NH
#720827033). This configuration uses the
auxiliary pump for header drive.
If it is necessary to convert from configuration B to
A, order B2837. Conversion instructions are
included with this kit.
B
A
B
A
C
CROP DEFLECTOR
INSTALL PINS - BOTH SIDES
A
B