Prescolite LF4LED IP65 - Manual

In
s
tr
u
c
tio
n
S
h
e
e
t
Part No...........................................
With representatives offices in principal cities throughout North America.
Copyright , revision, All Rights Reserved - Printed in U.S.A.
701 Millennium Blvd • Greenville, SC 29607
w
w
w
.p
re
s
c
o
lit
e
.c
o
m
P
re
s
c
o
lit
e
T
o
ll
F
re
e
T
e
c
h
n
ic
a
l S
u
p
p
o
rt
1
.8
8
8
.P
R
S
.4
T
E
C
H
o
u
rs
: 8
a
m
-
5
p
m
E
T
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
93052189
2014 08/14/14
WARNING – This product contains chemicals known to the State of California to cause cancer, birth defects and/or other
reproductive harm. Thoroughly wash your hands after installing, handling, cleaning, or otherwise touching this product.
INSTALLATION INSTRUCTIONS
IP65 RATED/VR ACCESSORY - LF4LED
The IP65-rated/VR accessory should be attached after the
trim/light engine and plaster frame are installed in the ceiling.
Locating and pre-drilling the mounting holes:
1. Pull the trim down and leave hanging from the springs
to locate the trim brackets (Fig. 1). Make small
reference marks to indicate the location of the trim
brackets.
2. Re-insert the trim into the plaster frame by pushing upwards.
The reference marks should be just visible past the
reflector flange edge.
3. Orient the metal ring so the holes avoid the trim bracket
locations (Fig 2). These places are where the mounting
screws will be installed, so make sure the ring is properly
positioned. Optional pre-drilling: using a 9/64” drill bit,
the marks can be pre-drilled to allow easier installation
of the IP65/VR accessory. Take caution not to damage
the reflector.
Ring installation:
1. For the IP65 accessory: remove the adhesive backing
from the larger gasket and install to the ceiling, aligning
with the previously marked or drilled holes. This gasket
is not used for the VR accessory.
2. Using a drill driver, insert one of the #8 self-tapping screws
directly through the ceiling material and into the plaster frame.
Do not completely tighten. Repeat for the remaining screws.
It is recommended to tighten all the screws equally to ensure
proper installation. The ring should be flush to the ceiling (Fig 3).
4LFLED TRIM
(FOR REFERENCE)
OUTER RING
GASKET
RING
ASSEMBLY
SCREWS
ACCESSORY
SHOULD BE
FLUSH TO CEILING
FIG. 1
FIG. 3
PLASTER FRAME
TRIM BRACKETS
FRONT GASKET
HOLE
FIG. 2
90° OUTER RING
GASKET