Belkin F1DW101AEAAU User Manual
Page 8
8
Installing your Server Interface Module
Step 5
Connect the Quad-Bus KVM-over-IP or CAT5 KVM Switch to the
Server Interface Module using the included Belkin CAT5e Patch Cable
or another CAT5 cable.
Server
Step 6
Repeat steps 2 through 5 for each additional USB server you wish
to connect.
Step 7
Power up all connected servers.
Step 8
Power up your Quad-Bus KVM-over-IP or CAT5 KVM Switch.
You are now ready to use your OmniView Quad-Bus Server Interface Module.
If you have any problems during installation, please refer to the OmniView
Quad-Bus KVM-over-IP or CAT5 KVM Switch User Manual.
Note:
Your server should recognize your Server Interface Module and automatically install the HID USB
driver if necessary.
P74940_F1DW101AeaAU_QIG.indb 8
9/1/07 5:19:01 pm