Prescolite SLLED2 - Manual

Instruction
Sheet
701 Millennium Blvd., • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2008, 9/12 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .93017297
Instruction
Sheet
INSTALLATION INSTRUCTIONS
RECESSED LED AISLE LIGHT SLLED2
1. Remove face plate and driver assembly by removing 10-32 tamper resistant screws and place them in bag enclosed.
Be careful not to lose any fasteners.
2. Secure the housing appropriately.
a. For concrete pour and masonry construction refer to Figure 2 and 3.
b. For drywall construction refer to Figure 4, 5, and 6.
3.Connect black fixture wire to black supply wire.
4. Connect white fixture wire to white supply wire and black fixture wire to black supply wire.
5. Secure face plate and driver assembly to housing using tamper proof fasteners removed during step1.
WARNING:
1. DO NOT pinch wires between LED faceplate, driver assembly, and housing. Consult a Qualified
Electrician for all other options that require other wiring configurations.
WARNING:
2. This Product contains chemicals known to the State of California to cause cancer, birth defects and/or other repro-
ductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
FIG. 1
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed
by qualified service personnel. Product must be grounded to avoid potential electric shock or other potential haz-
ard. Product must be mounted in locations and at heights and in a manner consistent with its intended use, and
in compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended
by the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
(2) 10-32 TAMPER RESISTANT
SOCKET HEAD CAP SCREWS.
FACE PLATE AND
LED ASSEMBLY
HOUSING
BLACK AND WHITE WIRE
TO BE CONNECTED TO
SUPPLY.