Prescolite SLLED3 - Manual

Instruction
Sheet
701 Millennium Blvd., • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2008, 9/12 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .93017298
Instruction
Sheet
INSTALLATION INSTRUCTIONS
RECESSED LED AISLE LIGHT SLLED3
1. Remove face plate and lens assembly by removing the 6-32 tamper resistant screws and place in bag enclosed.
2. Remove the 6-32 pan head screws securing the LED assembly to the housing and remove the LED assembly and place in
bag enclosed.
3. Remove wire nuts connecting the LED assembly to the driver bracket assembly.
4. Secure the housing appropriately.
a. For concrete pour and masonry construction refer to FIG. 2 and 3.
b. For drywall construction refer to FIG 4, 5, and 6.
5. Connect the black fixture wire from the driver assembly to the black supply wire.
6. Connect the white fixture wire from the driver assembly to the white supply wire.
7. Secure the driver assembly using the 6-32 screws provided.
8. Connect the black wire from the driver assembly to the black wire of the LED assembly using wire nut provided.
9. Connect the red wire from the driver assembly to the red wire of the LED assembly using the wire nut provided.
10. Secure the face plate and lens assembly using the 6-32 tamper resistant screws provided.
WARNING: DO NOT pinch wires between driver bracket and housing. Consult a Qualified
Electrician for all other options that require other wiring configurations.
WARNING: This product contains chemicals known to the State of California to cause cancer, birth defects and/or
other reproductive harm. Thoroughly wash hands after installing , handling, cleaning, or otherwise touching this
product.
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
HOUSING
(2) 6-32 PAN HEAD
SCREWS
FACE PLATE AND
LENS ASSEMBLY
(2) TAMPLER PROOF
6-32 BUTTON HEAD
SCREWS.
BLACK AND WHITE WIRE
TO BE CONNECTED TO
SUPPLY WITH UL APPROVED
WIRE NUTS.
LED/DRIVER ASSEMBLY
FIG. 1