Prescolite 93147 - Manual

Instruction
Sheet
www
.prescolite.com
• Prescolite
TollFree
Technical Support
1.888.PRS.4TEC
• Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .03379300
Instruction
Sheet
INSTALLATION INSTRUCTIONS
RECESSED AISLE LIGHT 93047, 93147
1. Install the conduit (by others) to align with tapped hole to be used in the
J-Box
2. Remove faceplate.
3. To install housing for concrete pour, fasten mounting brackets to
reinforcing steel or other structure. For drywall construction, frame in
the housing as required. The housing should be flush with the finished
wall surface for both wet and drywall construction (Fig. 2).
4. Remove the ballast cover plate and the J-Box cover plate.
5. Remove J-Box cover plate. Remove appropriate knockout and
assemble appropriate connector for the supply wire used. Connect
ground wires to green ground leads. Connect white (common) to white
(leads). Connect power supply (line) to the transformer leads marked
120V, 208V, 240V, 277V, 347V, or 480V, dependant or line voltage and
COM. All disconnected transformer leads must be capped off. Reinstall
J-Box cover.
WARNING: DO NOT pinch wires between J-Box/ballast cover and
J-Box. Consult a Qualified Electrician for all other options that
require other wiring configurations.
Replace the ballast cover plate.
6. Reassemble the faceplate.
“J” BOX COVERPLATE
RETAINED WITH
(2) SCREWS
Figure 1
BALLAST COVER
“J” BOX
ADJUSTABLE MTG. BRACKET (2)
FURNISHED IN PACKET
FACEPLATE
GASKET
TYPICAL
OVERLAP TRIM
MOUNTING
TYPICAL FOR
WET OR DRY
CONSTRUCTION
DRY
CONSTRUCTION
FACEPLATE
SCREWS (2)
HOUSING
CAUTION: If through branch circuit conductors are
pulled through the junction box, please use extreme
caution so as not to damage or disconnect thermal
protection wiring. Do not modify or defeat the thermal
protection circuit designed into the fixture.
Figure 2
WET
CONSTRUCTION
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.