Prescolite 84X - Manual

Instruction
Sheet
www
.prescolite.com
• Prescolite
TollFree
Technical Support
1.888.PRS.4TEC
• Hours: 8am - 5pm ET
101 Corporate Drive • Spartanburg, SC 29303
With representatives offices in principal cities throughout North America.
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .06248700
Instruction
Sheet
INSTALLATION INSTRUCTIONS
84X
Housing
Thick Ceiling Adjustment Screw (3)
Plaster Flange
1. Install the fixture in the ceiling using mounting channel, bar stock or 1/2" rigid conduit placed in the adjustable mounting brackets.
The fixture should be installed in such a manner that the weight of the fixture is supported by the mounting channels/bar
stock/rigid conduit and/or hanger wires secured to the building structure.
2. Adjust the fixture so the bottom edge of the plaster flange is flush with the ceiling line by sliding the mounting brackets and
secure using adjusting screws. The housing may be lowered further to compensate for thick ceilings by use of the (3) thick ceiling
adjusting screws.
3. Remove J-Box cover plate. Remove appropriate knockout and assemble appropriate connector for the supply wire used. Connect
ground wires to green ground leads. Connect white (common) to white (leads). Connect power supply (line) to black lead(s).
Reinstall J-Box cover.
WARNING: DO NOT pinch wires between J-Box/ballast cover and J-Box. Consult a Qualified Electrician for all other options
that require other wiring configurations.
J-Box Cover (2)
Adjustable Mounting Bracket (2)
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.